OBD 0 TO OBD I ECU PLUG RE-PIN CONVERSION CHART

JakeSpec wrote:No More Jumper Harness's no more octopuss harness under your carpet. Use this conversion chart i made to make your car obd 1 grey plug ready

things youll need.
1. eg / dc ecu plugs cut from a junkyard car minimum 3" long A B and D plug
2. a good crimper and about 55 non insulated butt conectors
3. about 2 feet of shrink tube
4. knee pads lol
5. 3m electrical tape
6. 20 ga electrical wire to make a vtec harness and a speedo harness from the speedo to the ecu to the cluster i will make this chart and post it later for you jdm cluster guys or dc or em1 cluster freaks.

and that should do it. make sure you cut 1 one! wire at a time and re connect to the new location

here's the chart excuse my detail of the ecu plugs i was in a hurry and also working while i did it hit me up if you need more info or some guidance!

i will show pics of my crx already done with no check engine light. and the best part is you can move the ecu without hearing the idle bump or try to stall!


MAXIMIZE YOUR SCREEN TO VIEW IN FULL

[You must be registered and logged in to see this image.]